Brand - FAB

ABOUT THE PRODUCT:

It is a semi-oily, alkyd-based road cartoon paint.

FEATURES:

Adhesive strength is very high and dries quickly. Wear resistant.

APPLICATION:

It is used in all kinds of necessary road markings and markings on road surfaces. The best results are obtained on asphalt surfaces. It is not recommended to apply on vacuum concrete surfaces as there will be less adhesion. FAB ROAD CARDER PAINT (210) The surfaces to be applied must be cleaned and dry. This paint can be applied with special spray tools or a pistol, brush or roller. Immediately after use, the instruments should be cleaned with FAB CELLULOSIC TINER (161).

INVESTIGATION:

Ready to use. 5-10% FAB can be solved with CELLULOSIC TINER (161) if necessary.

DRYING TIME:

(25 ° C / 65% relative humidity): Can be used after 20-30 minutes at 25 ° C. Tactile drying: 15 minutes, hard drying: 4 hours.

INTELLIGENCE RATE:

<23 c="" p="">

COST:

In a single layer, an area of ​​6-7 m² is painted with 1 liter of FAB ROAD CARD PAINT (210).

WARNING:

R11 can easily ignite. R36 is harmful to health when inhaled.

SECURITY MEASURES:

Q 2 Keep out of reach of children. S 3/7/9 Keep the box closed and in a cool and well ventilated place. S 23 Do not inhale steam S 24/25 Do not touch skin or eyes. Q 29 Do not throw into the sewer. S 37/39 Use appropriate goggles and mask when working.

PROBLEMS THAT CAN OCCUR WHEN USING:

If the surface is excessively dirty, the paint may peel off without sticking. If you encounter these and similar problems, you can contact the technical service with the batch number on the box and take a closer look at your problem.